We've all been there — elbows, chin, that one friend you promised beer to, whatever it takes to hold a miter joint. The Miter Clamp says none of that is dignified.
The Miter Clamp. Because holding a miter joint with your chin while you nail it was never a good look.
Lightweight, fast, and stupidly simple, this little clamp features a lever action that snaps to a positive stop, locking your miters down tight so you can glue, nail, or just admire your perfectly square corner in peace. Now made with a carbon fiber infused blend of plastic, because your old clamp called and said it wants to be tougher.
Why the Miter Clamp Is the Best Thing to Happen to Your Corners Since Sandpaper
-Lightweight and compact, it won't weigh down your tool belt or your soul.
-Lever action comes to a positive stop, no guesswork, no wobble.
-Secures miters from 1/2" - 1 1/8" thick moldings.
-Flips flat on either side with zero interference, so you can clamp thinner moldings right on the table, or reach up and nail those tricky outside crown corners at ceiling height without a fight — because nobody wants to be the guy on a ladder yelling for a hand at eight feet up.
-Grips tight enough to hold your joint steady through glue-up and nailing, even on moldings that aren't perfectly straight — no white knuckles required. Your joint stays put, your dignity stays intact.
-Leaves barely a mark, we promise your moldings will forgive you.
-Recommended for molding width of 3 1/2" and under.
-Inner components are interchangeable, so spare parts are always just an order away.
Designed and built right here in the U.S.A., patented, and good enough to get featured in Fine Homebuilding Magazine. Not bad for a little orange clamp.
Featured in Fine Homebuilding Magazine Issue #321 - Feb/Mar 2024